ATA PTX4 REMOTE CODING INSTRUCTIONS:
Press and hold the “code set” or “learn” button on the motor box through out this process, select a button on your remote (more than one button can be coded in), hold your remote close to the motor box, whilst your finger is on the “code set” or “learn” button, press and hold the desired button on for three seconds, off for three seconds, on for three second and then off for three second. Release the code set button. Your remote will now be coded.
ATA PTX5 REMOTE CODING INSTRUCTIONS:
Turn the power off to the garage door/gate, Remove the light cover of garage/gate motor (if required). Remove the existing plug from the labeled P.E Connectors. Insert new plug with 2 red wires on to the P.E connectors (where the original plug was previously). Insert the white, black and blue plug on to O/S/C connectors. Turn the power back on the garage door/gate. Using a needle, press and hold the code 1 button on the newly installed receiver. Using the ATA PTX5 remote press the button (for two second) you would like to use to control the door. Release for two second, press for two seconds then release the button again. Test the remote.